Initial Configurationīefore following these steps, install a router as shown in the diagram above. Most new users will benefit by starting with this simplified approach to become familiar with PtMP or to serve a smaller, limited area. That however, is not the scope of this article. Clearly, a more complex approach is often desired, one that uses multiple Ubiquiti radios with sector antennas along with a fully routed (rather than bridged) configuration. This example is the simplest, using a single Ubiquiti radio with an omnidirectional antenna to create a bridged network. There are many approaches to providing PtMP services. PtMP links are used routinely to serve up to 100 locations from a single Access Point. Configuration for the the Cable/DSL Modem.Configuration for Radio Labeled 192.168.1.2 (Access Point).The settings are very similar with just small modifications that will be pointed out for the different platforms. The instructions below offer the configuration for both AC and M devices. This article describes the configuration needed to create a Point-to-Multipoint (PtMP) link for airMAX devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |